Frage Zetor 6211 - Air Pressure Gauge

N

Nevin

Mitglied
Dabei seit
8.03.2021
Beiträge
73
Ort
Ireland
Vorname
Eoghan
Traktor/en
Zetor 6211
Hi all,

I was reading through Joachim's walkthrough of troubleshooting the air pressure system. Very helpful :like

I then had a question or two.

Where do I go to relieve the air pressure in the system?

How do I refill the system ( start tractor ?) Is there a regulator in the system to ensure its not over-pressurized?

What should the reading be on the gauge when working normal?

Are the 2 connection sensor's polarity sensitive?

Thanks,
Nevin

 
Where do I go to relieve the air pressure in the system?
Compressed air tank underside

How do I refill the system ( start tractor ?
Yes - naturally. ;)

Is there a regulator in the system to ensure its not over-pressurized?
Really now? So if you can't find the pressure reducer, you'd better not screw on the brake system yourself or on your own. :denk2:
What should the reading be on the gauge when working normal?
6,5 bar
Are the 2 connection sensor's polarity sensitive?
No, but works only when you connect it the correct way. :)
 
Thanks for that information :Like.

Is there any + and signal indication on the sensor or just try one way and change if not working?

Does it take long to build to 6.5 bar?

Thanks,
Nevin
 
I have since done a bit of checking at the tractor on this subject.

I found the two cables to my encoder / air pressure sensor were broken, so repaired them and connected them to the sensor and swapped them other way around

At the gauge once key is pushed down it automatically goes all the way past 10 and off scale.

Du hast nicht die nötigen Rechte um Anhänge (Bilder, Dateien) anzuschauen.
Bitte registriere dich jetzt oder logge dich mit deinem Account ein um Anhänge betrachten zu können.



I have tested both cables to sensor for short to ground but nothing, they seem clear.

I disconnected sensor cable at gauge and just left in earth and + 12V and touched sensor pin with a good ground and didn't move at all from reading off scale above 10.


Du hast nicht die nötigen Rechte um Anhänge (Bilder, Dateien) anzuschauen.
Bitte registriere dich jetzt oder logge dich mit deinem Account ein um Anhänge betrachten zu können.


Here is a picture of a back of gauge wiring.

Blue is + 12V
Grey is Earth
Green is sensor cable back from earth

Brown is just lamp 12V

Also I have checked the continuity of green cable back from sensor to gauge and it's fine.

Is my gauge faulty? - would like to clear or eliminate that before seeing if it's sender


Thanks
 

Anhänge

    Du hast nicht die nötigen Rechte um Anhänge (Bilder, Dateien) anzuschauen.
    Bitte registriere dich jetzt oder logge dich mit deinem Account ein um Anhänge betrachten zu können.

Ähnliche Themen

R
Antworten
6
Aufrufe
402
christian_vogtland
N
Antworten
14
Aufrufe
3K
Joachim
N
Antworten
6
Aufrufe
540
Nevin
N
Antworten
13
Aufrufe
2K
Joachim
Zurück
Top